What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 05:24

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is where this question deviates from being a 'generic' question, and becomes more specific.
One is “what exactly is in a ‘surge protector’ ? ”
If You Can Perform These 5 Moves at 60, Your Body’s Decades Younger - Eat This Not That
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Upvotes:
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
I post the exact comment here.
Here is a simplified AC power diagram.
The third is lightning and “how it gets conducted into a home.”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is 'the assistant's answer'
Microsoft confirms auth issues affecting Microsoft 365 users - BleepingComputer
but I think this circuit , shows a few more pieces.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2025 Audi Q5 And SQ5 Are Pretty, Pretty Good - Jalopnik
He then describes Rainy Season and Lightning.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
(Dc diagram shown, AC is similar).
Hegseth moves to rename Navy ship honoring gay rights icon Harvey Milk - The Washington Post
Because the load is inductive, the current lags the voltage.(by a bit).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–16 [ OO OLAOYE OYEBODE ]
Which AI tool is capable of writing code and creating software from simple instructions?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–14 [Omar Gharbi Omar Gharbi ]
Now when you have a certain ac resistance, then a current flows in a loop.
Oy: United Jet Flies Wrong Route Departing SFO, Causes Near Disaster - One Mile at a Time
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
but this device (an Inductor) … impedes the rapid changes in the current.
There are three different concepts here that are getting confused.
Logitech Announces Two New Accessories for WWDC - MacRumors
But it can get overloaded, and no longer works.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The bolt then partially travels down the line to your home.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Immunotherapy Drugs Show Major Progress in Early-Stage Cancer - Bloomberg.com
[old diagram got deleted by accident]
The MOV will conduct when the voltage exceeds 50% of line voltage.
Edit 2024–10.
Juror Dismissed In Sean "Diddy" Combs Trial For Perceived "Lying" - Deadline
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
He then describes the function of a fuse.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At one ohm, the resistor has a maximum of 1 watt power.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A circuit breaker is similar, but is resettable.
The other is “what does a “fuse” do?”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It also is a device that limits the change in current flow.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This one hit behind the barn.
nine
He then asserts :
[image of Common-mode choke]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
First Sentence:
So, the voltage could go up to 500 volts, and the fuse will not open up.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
What is lightning?
In schematic diagrams this is the symbol for a fuse:
For this case there are devices called Metal oxide varistors (MOV).
At least they know the answer if they wanted it.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
the problem then depends on "how fast does the fuse operate?".
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is where the MOV conducts again, and dissipated the energy.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
These devices are installed between the “hot” and “neutral” and protective ground.
Barnstars:
2024–10–10[John johnson John Johnson ]
A fuse is a non-resetable over current circuit protector.
a photo is worth a thousand words.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
An AC voltage/ current source, and an ac inductive load.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This device then solves the entire problem.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
These are simplified answers to the original question, and does not change anything I wrote above.
eight
Can the fuse protect the electronic devices from lightning instead of a surge protector.
One
It seems Mohan does not understand the difference between a comment and an Answer.
so, what happens?
what exactly is a ‘surge’ protector?
What does a fuse do?